o2 Sensor Bung

o2 Sensor Bung

SKU:
WS02SB1
|
UPC:
WS02SB1
Availability:
Usually ships within 1-2 days
C$15.64
(No reviews yet)
Current Stock:
Adding to cart… The item has been added
Description

This weld-in bung allows an O2 sensor to be screwed into your exhaust system. It's required for custom exhaust systems, and is also useful for air/fuel ratio measurements when dyno testing. A threaded plug is included to cap off when not in use. 

  • Locate bung as close to engine a possible, without exceeding the maximum operating temperature for the O2 sensor. The suggested location is just down-stream of the merge-collector on each bank of cylinders.
  • Sensors located after upstream exhaust system leaks or too close to exhaust outlets are susceptible to poor readings or influence of ambient air
  • O2 Sensors exposed to exhaust gasses with too high amount of un-burnt fuel can lead to misleading readings. A possible lean reading.
  • Locate sensor/bung 90° to exhaust gas stream.
  • Locate sensor/bung in tube with a minimum of 10° up angel to prevent liquid build up in sensor element.
  • Use stainless steel welding wire or rod when installing bung.
  • Do not have bung plug or a oxygen sensor installed when welding bung in place.
  • Welding can distort the bung so it is recommended you chase/tap the threads of the bung after welding.
  • When installing O2 sensor or plug, use an O2 sensor compatible high temperature resistant grease on the threads.
  • Use tightening torque suggested by O2 senor manufacturer.
    •

*picture may not depict actual item