OEM Rotor (Modified No Resistor) for all 4 and 6 cyl 123 applications
123Ignition
$NZ76.27
$NZ83.99
(You save
$NZ7.72
)
(No reviews yet)
Write a Review
123Ignition
OEM Rotor (Modified No Resistor) for all 4 and 6 cyl 123 applications
This is a modified no resistor rotor we do in house. It can be used on all 123ignitions but is intended to lengthen the life of the cap and rotor when used in conjunction with CDI units like Winterburn and MSD
Why No Resistor?
"The rotor resistor was an early attempt at radio noise suppression. Same role as the resistance in spark plug wires and the spark plugs. No other reason. The resistor actually causes the secondary side voltage to rise slightly higher by a few percent before spark breakdown so the voltage overshoot is higher. Without the resistor there is less voltage stress on the coil, distributor cap, rotor, and spark plug wires. In addition, once spark breakdown does occur that added resistance will reduce the spark energy due to the current limiting it provides. For CDI use, the resistor should be removed and replaced with a piece of wire, or eventually the higher power of a CDI will cause the resistor to go open-circuit" - Contributed - Frederick C. Winterburn
Additionally the OEM Rotors just fit better due to the parallel bore and step design to fit the 123 shaft. See these pictures below. The one on the left is the standard aftermarket and is a tapered bore. The center and right are the oem and an attempt to show you the parallel and stepped bore which give a very secure fit.
Related Products
-
-
-
Sale
Ignition Rotor All 4-cyl to 1974
$NZ4.24$NZ8.38 -
